Intank Fuel Pump Wire

Non-EMS Automotive related discussions and projects in here please.
Chen
TO220 - Visibile
Posts: 14
Joined: Thu Nov 13, 2008 2:52 am

Re: Intank Fuel Pump Wire

Post by Chen »

User avatar
SleepyKeys
LQFP144 - On Top Of The Game
Posts: 549
Joined: Mon Feb 11, 2008 10:52 pm
Location: Arizona
Contact:

Re: Intank Fuel Pump Wire

Post by SleepyKeys »

You snooze, you lose!
User avatar
longracing
LQFP112 - Up with the play
Posts: 140
Joined: Wed Jul 16, 2008 9:21 am
Location: NSW, Australia

Re: Intank Fuel Pump Wire

Post by longracing »

Working on Boeing Aircraft they used nickel plated wire with teflon insulation in the fuel tanks. The ends used crimp-terminals. They usually do not need sealant over the terminals but that would help protect them from corrosion. Make sure the wiring is well supported in insulated clamps & that there is no chance for the wires to chafe and short out.
User avatar
jharvey
1N4001 - Signed up
Posts: 1607
Joined: Tue Jun 10, 2008 5:17 pm

Re: Intank Fuel Pump Wire

Post by jharvey »

Also of interest, about boeing / planes, they have a device with micro membranes that will mechanically seperate nitrogen from passing air, which is then pumped in the fuel tanks. Even with those insulation considerations, they still had spark issues, and needed to fill the unused tank space with N2.
User avatar
longracing
LQFP112 - Up with the play
Posts: 140
Joined: Wed Jul 16, 2008 9:21 am
Location: NSW, Australia

Re: Intank Fuel Pump Wire

Post by longracing »

The problem with the Boeings was on the 747 aircraft. The large center wing tank always empties first. When the air-conditioning units underneath the tank are left on for a long time on the ground this warms & vaporises the fuel. The ignition source comes from inside the pumps which use the fuel to cool them internally. When the pumps are left on for too-long while they are cavitating they over-heat and that causes the fuel to ignite.
Post Reply