HELP tpi 3501988 corvette needwiring diagram
-
- TO92 - Vaguely active
- Posts: 1
- Joined: Fri Feb 25, 2011 10:58 pm
HELP tpi 3501988 corvette needwiring diagram
im wiring a tpi 350 corvette motor into a holden monaro and not 100% sure of how to hook it up need to know were to hook up battery, ignition,fuel pump,engine fans,etc.etc can anyone please help i am a autoelectrician but do not have the info i need got a good idea but not 100% sure
Re: HELP tpi 3501988 corvette needwiring diagram
Hello and welcome along.
I don't know much about Corvette wiring, and I don't have a diagram. Perhaps I can help if you give me more information. Is this fuel injected, a MS conversion, or is this using OEM wiring. I don't know what you have or what you need to wire. Perhaps you can elaborate.
I don't know much about Corvette wiring, and I don't have a diagram. Perhaps I can help if you give me more information. Is this fuel injected, a MS conversion, or is this using OEM wiring. I don't know what you have or what you need to wire. Perhaps you can elaborate.
Re: HELP tpi 3501988 corvette needwiring diagram
Hi Peter,
There is some information here ftp://ftp.diy-efi.org/pub/gmecm/manuals/
or you can ask on http://www.thirdgen.org/techboard/tpi/ or http://www.ls1tech.com/forums/
Con
There is some information here ftp://ftp.diy-efi.org/pub/gmecm/manuals/
or you can ask on http://www.thirdgen.org/techboard/tpi/ or http://www.ls1tech.com/forums/
Con
previously: ca7