Page 1 of 1

Forget buying an enclosure, build one yourself :D

Posted: Fri Dec 16, 2011 4:28 am
by thebigmacd
You'll like this one Fred, he's a New Zealander!

http://blog.rhysgoodwin.com/fabrication ... enclosure/

Re: Forget buying an enclosure, build one yourself :D

Posted: Fri Dec 16, 2011 10:08 am
by Fred
Cool! :-) Way too heavy for this application, though, in general, or am I obsessed with chassis dynamics? Some good ideas, though. You could make a Three piece mold with thinner walls and a drain at the bottom, then line it with fibres of some sort and pour it full until it came out and then plug the end. Sadly, I'm tool free here, so anything of this nature will be a hell of a challenge without spending heaps on equipment.

Re: Forget buying an enclosure, build one yourself :D

Posted: Mon Aug 19, 2013 8:19 pm
by DanMoto
That's a heavy process for just a case. Good thing I have a 3D printer for this. :D Much easier and quicker.