Let me introduce myself
Posted: Tue Mar 04, 2008 10:08 pm
Hello all,
I was introduced to this forum by 8InchesFlacid. I have been running MS2/E on my vehicle for the last 5 months and have been extremely happy with it, because I was able to figure out my way around it. I have not, however, been happy with the "open source" spirit that it was originally intended to have. Least to say, I was excited to hear about this project.
I have a good amount of knowledge in electronics, nothing too extensive, but enough to build my own MS and create circuits for it. I have done a little bit of work with Mitsubishi 6111 processors which are very similar to Motorola 68HC11 processors. The 6111 is used in DSM ECUs. I did quite a bit of tinkering with the factory code in both modifying and making code to make use of the unused outputs. I also have a fair knowledge of EFI strategies, enough to make my car run well. I also do fab work and welding where needed on my projects, and have also done a little bit of welding for 8InchesFlacid.
I fully support this project, and would be more than willing to help out where I can. I've been breifed a little bit on it so I'm going to take a look around and get a good feeling of what's going on.
I was introduced to this forum by 8InchesFlacid. I have been running MS2/E on my vehicle for the last 5 months and have been extremely happy with it, because I was able to figure out my way around it. I have not, however, been happy with the "open source" spirit that it was originally intended to have. Least to say, I was excited to hear about this project.
I have a good amount of knowledge in electronics, nothing too extensive, but enough to build my own MS and create circuits for it. I have done a little bit of work with Mitsubishi 6111 processors which are very similar to Motorola 68HC11 processors. The 6111 is used in DSM ECUs. I did quite a bit of tinkering with the factory code in both modifying and making code to make use of the unused outputs. I also have a fair knowledge of EFI strategies, enough to make my car run well. I also do fab work and welding where needed on my projects, and have also done a little bit of welding for 8InchesFlacid.
I fully support this project, and would be more than willing to help out where I can. I've been breifed a little bit on it so I'm going to take a look around and get a good feeling of what's going on.