Page 1 of 1
Automotive YouTube thread
Posted: Wed Apr 02, 2008 4:19 pm
by Fred
Hi,
I don't really have anything to post here just yet, but I thought I'd stick it up and put a link to the diyefi.org FreeEMS vids in this first post.
http://www.youtube.com/profile_videos?user=diyefi&p=r
Chuck up your Car/Truck/Bike/Boat/engine/efi/etc automotive related links! Preferably post a rough length with them so people know what they are getting themselves into time/bandwidth wise.
Fred.
Re: Automotive YouTube thread
Posted: Sat Apr 05, 2008 3:57 am
by Jake Breyck
heres is my supra starting up with the 1uz v8 for i think the 2nd time, Open header
http://www.youtube.com/watch?v=AhHwaWE9uSE
Re: Automotive YouTube thread
Posted: Sun Apr 27, 2008 1:22 pm
by Fred
This thread has been pretty dead, so I have a few to add to it :
This mini video is pretty impressive, I've seen it a few times, but always worth a rewatch (watch to the very end) :
http://www.youtube.com/watch?v=x4qRVfioR2g
And these two Romanian vids are hilarious IMO :
http://www.youtube.com/watch?v=nzT8tAzWik4
http://www.youtube.com/watch?v=u8gXAd0R0rM
Fred.
Re: Automotive YouTube thread
Posted: Sun Apr 27, 2008 11:13 pm
by slacker.cam
This is one of my favourite youtube vids of all time. Not sure if it was luck of skill but damn impressive either way.
http://www.youtube.com/watch?v=D6nJola1Ei8
Re: Automotive YouTube thread
Posted: Mon Apr 28, 2008 6:22 am
by Fred
Luck landing the way he did, skill doing what he did afterwards :-) Seen it before, and it is good.
Re: Automotive YouTube thread
Posted: Fri May 09, 2008 6:36 pm
by Fred
http://www.youtube.com/watch?v=PwvIRuCLbyg
Tarmac rally on the isle of mann from 1983. About half way through, listen to the navigator :-) SO funny!
Re: Automotive YouTube thread
Posted: Fri May 09, 2008 6:48 pm
by jbelanger
Re: Automotive YouTube thread
Posted: Sat Oct 04, 2008 1:12 pm
by Fred
Re: Automotive YouTube thread
Posted: Tue Dec 18, 2012 6:41 am
by TheRevva
OMFG!!!
I just opened up the DIY EFI YT for a quick 'look see'.
A few vids down I came across THIS link (Bruce Bowling: "Noise - it's all your fault!"):
http://www.youtube.com/watch?v=zIi2_lCcazs
Firstly, it's over an hour in length! Did you READ that? OVER AN HOUR!
And then there's the title... I'm speechless!
I could only watch it for 5-10 mins (but I'll definitely keep it mind for those insomnia-type winter nights, or perhaps when I need a good laugh!)
Personally, I'd suggest avoiding having to continually make the "I screwed up" comment every minute or so when trying to describe my circuit design.
(Perhaps by trying something really radical... Peer review? Skill and prior experience? Common sense?)
Phew!!! I almost went that route!
Re: Automotive YouTube thread
Posted: Tue Dec 18, 2012 8:57 am
by Fred
LOL, pretty much. I was:
1) Equally stunned when I first saw it.
2) Elated when I re-found it later and cached it there