- TPS setup assistant
- BRV calibration/fine-tuning assistant
- Output scheduling wizard
- Thermistor (IAT/CHT/etc) curve library, generator and viewer
- Decoder offset assistant
- MAP/AAP sensor library and assistant (for unknown sensors)
- MAF sensor library and 1D parametric tuner (for unknown sensors)
- Capacity to cylinder volume assistant (unit converter)
- Injector flow library and assistant (mass-volume flow conversion, pressure scaling)
- Fuel type library and blend calculator (density and stoich)
- Tacho config wizard (configure settings based on decoder setup)
- RPM calculation config wizard (future setup is highly configurable and decoder dependent)
Thermistor curve gen/view is pretty easy, maybe do this next.
Scheduling wizard is tricky/complex, this is a "later" thing for sure. MUST have advanced/manual mode, too. Will likely be profile based eg:
- Distributor
- Dual distributor
- Wasted spark
- COP/CNP
- Sequential
- Semi-sequential
- Multi-shot
- Ugly long pulses
- V-twin
Fred.