DIYEFI.org Forum

Salae logic logs at different rpms.
first channel is inj 1
second channel is inj 2
3 and 4 are ign

3500:


5500:


6300:

anglesOfTDC: {ANGLE(0), ANGLE(180), ANGLE(90), ANGLE(270)}, outputEventPinNumbers: {1,0,2,3}, // Wasted spark, semi-sequential schedulingConfigurationBits: {0,0,1,1}, // First four ignition, last four injection decoderEngineOffset: ANGLE(100.00), numberOfConfiguredOutputEvents: 4, // See two lines a...

I don't see any sync loss on logs neither injection/ignition cut about the possibility of being a rich mixture which can cause missfires could be, but is strange as I started with a very low VE, and I went increasing it by 5 units each test. I only uploaded 2 logs but I've done a lot more tests. Abo...

I made today some tuning but I'm having problems above 4500 rpm over 80kpa. I've lean spikes. Driving it feels like some injection cuts.I've tried with different VE's but is the same for example: http://i.imgur.com/F49nP9T.png which can be the reason? I remember to have similar problems a few ages a...

I've to made some mods to made compatible ms1 v3.0 stock board with ruzkiboard as the ruzkiboard was made for ms2 with sequential injection mod: - use std injector pins 21-22 instead of 39-40, - change megasquirt injector FET driver (inverted) for a non inverted one - adapt configuration for the por...

After a sabbatical year with a NA V6 and then with stock engine it will have a 2.0 turbo again. This time I'd like to install (and use,not like last time) a FreeEMS instead of my MS1.In first instance I would like to use the ruzki board so I can keep my current megasquirt board. I've also a Jaguar 0...

that's a really nice car!

but without videos of it throwing flames out of the exhaust is no nice post

Hi, could you send me the driver source code?

ok good, that is enough for me if I can see the data format

I've just ordered one + another wb for a friend. Could be nice to receive them before end of month

I mailed Alan a few months ago asking about this product but had no answer. Now I really need to buy a WB O2 sensor for a car I'm rebuilding so I open this topic because probably another person has the answer and can help me to decide buying this product or search for another one. I like the SLC DIY...