DIYEFI.org Forum

CodeWorrier won't do you any good, FreeEMS uses an open source toolchain found at http://tools.diyefi.org/ Development boards can be ordered from http://www.coolefi.com or http://www.technologicalarts.ca IRC = Internet Relay Chat We can be found on irc.freenode.net on the following channels: #freeem...

Here are a few photos of the S10

I figured it was time to upload a few photos

More than likely you don't have a 12v supply that is supposed to be connected to the IGN-12v input which supplies 12v to the JP1 and JP2 jumper block. Right now you are probably only feeding the ignitor driver with 5v from the MCU output. This would explain the 2v drop across the 1k resistor and the...

Also, while looking at page 5 of 7 of the schematics, on the Ignitor Outputs, I noticed that there is a jumper o select between 5v and 12v. Do I need to anything to this? If you look in the upper right hand corner of the Jaguar PCB (holding it so you can read " Designed by Andy Goss " rig...

I have a GM 3800 series 2 Cool, I have a GM 3800 Series 1 v6 in my 1989 Oldsmobile Toronado Trofeo, it was used to provide ignition data to Fred when we were working on getting the GM wasted spark control setup for FreeEMS :) the ICM can drive the bank fire coils just fine however it requires a 5v ...

On the fuel pump its great to know that I can activate the relay on the high side, since i wired all my relays like this, so i shall connect them like: Fuel Pump https://cloud.masterkorp.net/index.php/s/AB4fxllaUa7a2PA/download So I connect the HSD to the 12V relay, and the FP is a ground that can ...

I will take a crack at answering your questions: How is Cam Angle Sensor support? I know this is an ongoing development, I'd like to know what is necessary for me to do? Do I need any extra circuit logic? I know that Robs Skyline is a work in progress at the moment. As far as I know you shouldn't ne...

AldoQ wrote:Hi
i want 1 bare pcb and bdm
regrds

PM sent to AldoQ with cost and shipping information request.

Alekss, you will want to start with the information in this release (0.7-alpha), as it is the current hardware release version: https://github.com/DeuceEFI/Jaguar/tree/0.7-alpha or: git clone https://github.com/DeuceEFI/Jaguar.git cd Jaguar git checkout 0.7-alpha Then look in the " docs " ...