DIYEFI.org Forum

Is there a user's guide for EMStudio anywhere, or some sort of How-To , to show me how to configure my FreeEMS ?

TIA,

Dave.

Hello, So, I have firmware version FreeEMS-0.2.0-SNAPSHOT-274-gb247e56-MissingTeeth-Crank-36minus1 Is this the latest general release firmware ? I'm just waiting for my Jaguar board to arrive and then I can test it on the bench. I have a small electric motor with a 36-1 wheel on it and a real VR sen...

Hello Fred,
Are you allowed to tell us what the engines were and how fast they rev ?

TIA,

Dave.

Hello All,
Am I going to have problems using a 36 - 1 toothed wheel at 15,000 rpm ?

TIA,

Dave.

I don't have any hardware yet, I have just ordered a Jaguar 0.7 from DeuceEFI but haven't got it yet.
I assume that you need an engine spec. in this build thread ?
Where is the correct place to put it?

Hello All, I was going to post some photos of my Honda VFR400R NC30, but the forum thinks my jpeg files are invalid :( Anyway, hopefully I will be fitting a Jaguar 0.7 FreeEMS board to the bike soon. I was concerned about something I read here about the missing tooth decoder being unable to handle h...

115kPa please

Thanks,

Dave.

Normally Aspirated, it's my bike project.

TIA

Dave.

Hello,
Have I missed the boat on this ? If not, I am interested in an Option #3 board only, with either 115kPa or 250kPa sensor, and
shipping to the UK.

Thanks,

Dave.

Hello All,
Yes, that is my custom made throttle bodies, they are the same dimensions as the carbs that came off,
so they fit the cast airbox bottom. Hopefully, this will make sure they stay in sync. Once I get it running I'm going
to attempt to stretch my spare engine to 500 cc .

Dave.