DIYEFI.org Forum

not sure i think the refresh rate is as weak as the scangauge on those
but i will try if i get my hands on one.

i have ultra gauge for basic troubleshooting and autel 708 scanner also neither one works for my purpose the 2005-up RL comes with 2 widebands stock and i dont know any good way to interface with them to just get a readout to a gauge or two separate gauges one for each bank is there anything similar...

ok that makes sense. are there any obd2 port adapters like scangauge or similar that would read air fuel ratio? I tried ultragauge but it doesn't show it just long and short trim. the only way to change anything would be a vtec controller and adjusting fuel pressure as far as I know. after adding bo...

acura RL readings from the stock wideband sensors without affecting the voltage that goes to the ECU from those wideband sensors because of the SH-awd theres no k-pro or any kind of ecu mods but I'm so used to having a wideband gauge in my car. I want to add one to this car but since it uses 5 wire ...

05 RL came with 2 widebands one for each bank

what would be the best way to get readings from both of them?

I was reading that hooking up an air fuel gauge will affect the voltages and fueling

Crome is cheap.
When you got 4 hondas with stock ish motors its best thing

well didn't take long to find a perfect heatsink for the wideband. lucky I have a lot of leftovers from upgrading stock coolers on my computer builds. a graphics card heatsink with a drilled exact diameter hole is perfect for the job http://g01.a.alicdn.com/kf/HTB1qTjjHVXXXXb5XpXXq6xXFXXXT/80pcs-55m...

well I got the DM-6 PLX wideband kit. I didn't read the reviews prior to buying which I should have gauge doesn't work, or doesn't work when cold is what I see. so mine doesn't work either right out of the box... and since its a short review. as many others said theres no way to mount the gauge. I'm...

Its not an issue its an algorithm that vonverts 5 volt to 3.67 volt for stock program for whatever reason Crome only accepts one input as o2 sensor input If you re using ostrich.hulog combo theres no other inputs available. I got the thing calibrated but its much easier to use serial output when im ...

but lean afr will cause egt to climb up to a certain point... and when car is running rich theres a lot of unburned fuel and is much colder than a very lean exhaust gas. does it help to have the sensor out of the exhaust flow with the extended bung? how long is enough to get the sensor clear of the ...