I figured it out. The pinout is the same as the more conventional 'D' shaped connector.
I'm up and running.
Search found 4 matches
- Sun Aug 30, 2015 2:53 am
- Forum: General FOSS EMS
- Topic: Bosch LSU4.2 with square connector
- Replies: 3
- Views: 16708
- Thu Aug 27, 2015 10:16 pm
- Forum: General FOSS EMS
- Topic: Bosch LSU4.2 with square connector
- Replies: 3
- Views: 16708
Bosch LSU4.2 with square connector
Hello, I bought one of Alan To's WB controllers but am to the point where I've realized the connector on my WB sensor is different than what was supplied in the kit. I have a Bosch 17033 sensor from what I can tell and it uses a square 6-pin connector. The harness side uses a connector with a gray l...
- Tue Aug 18, 2015 2:07 pm
- Forum: General FOSS EMS
- Topic: AEM WB consitently lean on analog output
- Replies: 7
- Views: 25316
Re: AEM WB consitently lean on analog output
Thanks for the replies. I read the WB thread, very informative. I've found plenty of posts online in my research now about AEM analog outputs being inaccurate so it seems I may be asking for something it cannot deliver. That said, I ordered a controller from Alan yesterday. Looking forward to gettin...
- Mon Aug 17, 2015 3:36 pm
- Forum: General FOSS EMS
- Topic: AEM WB consitently lean on analog output
- Replies: 7
- Views: 25316
AEM WB consitently lean on analog output
Hello, First post here so I'll try not to be too annoying. I'm working on tuning a new engine for my 2007 Mustang. I have an AEM wideband setup that is using a LSU4.2 sensor. I am tuning with HPTuners and have the 0-5V analog output from the gauge installed on one of the analog inputs of the tuning ...