DIYEFI.org Forum

thanks for your help

hi, I'm actually working on a project base on Arduino Uno ( or Mega ) to read sensor on my old VW engine And during my research I have discover the Arduino Die board based on an Atmel cortex M3 a 32 bits ARM did you think a portage of your code is possible ? because I found of all project base on Ar...

thanks

ok
I go work on this
but no documentation for dialog use between freeems firmware and emstudio.
I would use the same output and format for data than freeems

Hi all

I m working on project base on Arduino
My goal is to read information from différent sensor like oil pressure température rpm etc
I would use emstune for graphical résult
Did You have a documentation about your input format so I can send them to my serial port

Thanks for your help

I plan this type of installation for trigger wheel



for the redline of the engine I think 6500 rpm

hi,

After lot work on my vw westfalia bus 1976, my engine run

I didn't get all the part like injectors
so I would if I can run free-ems only for ignition ?
just a trigger wheel and coil-pen for ignition
a simple use like the megajolt board

+1

nice work Andy

nice car
I have own a 55 with sunroof, a 52 and now I have a 65
but I prefer bay-window camper for long week-end with my family