DIYEFI.org Forum

1. 512K 32K of which is always accessible. 2. 10000 write/erase cycles per block (4 blocks) I know that the two ecms I have used on my bikes have the ability to store data for later download and display. Can you please give me some idea of how they are doing this? For instance the last 30 minutes o...

Please READ your PM. If you keep editing messages at the rate you are I will remove your ability to edit posts.

If you remove my abilit to edit my posts I will leave the forum.

Any threads on integrating the tool chain with eclipse?

wonder why you are told that I won't be writing such code.

Any suggestions I have do not assume that you will have to write the code. I plan to be fully capable of writing any special code. That is one of things that I hope to learn here. I will write the code that implements the auto-tuning.

How much flash memory is onboard this microprocessor?

What are the problems with writing to flash memory?

Does the current design have a datalog capability? If so, where is the data written?

The programming for this is not significant AT ALL.

I think you misunderstood some of my words in my prevous post.

I dont want to argue about this anymore. Hopefully the ems will be designed in such a way that evolving it into different directions will be easy.

What you will have a very hard time convincing me of is that I should allow my computer to adjust the tune that I have set in it based on sensor readings when wires could fail, sensor could be damaged, sensor controller could fail, etc etc etc etc on a long term basis when these things really happe...

I sincerely hope that you don't have too many questions though,

Fred, lighten up. If I have questions I will find the appropriate person to ask. I am not going to burden you.

On a motorcycle changing exhaust, heads and cams is done quite frequently. Also you are not using just map to estimate air flow, you are using the o2 sensors to MEASURE the air flow. From the 02 sensor measurement you can correct the volumetric efficencies. Please forgive me for being so blunt here,...

The thread in the articles section proved to be very helpful. I know have the tool chain compiled.

I will download your code and integrate it into eclipse and see if I can complile it. Once I get to that point I will start looking closely at your code and will probably have lots of questions.